Aston Global SEB976, Installation And Owner'S Manual, Page: 13 / 27

2. Using the appropriate drill bit for your wall surface drill the hole locations with a
5/16" diameter drill bit. Install the plastic anchors provided into the drilled holes.
3. Remove the wall mount (7) from the rail end (6). Using the hardware from
Screw Pack 2, install the wall mount (7) on the wall.
4. Position glass clamp (8) on floor and attach to floor using M4 x 40 screw from
screw pack 2. The glass clamp should be positioned so the single hole is facing
toward the inside of shower. See figure 7.
5. Slide rail end (6) onto top rail (2) and loosely tighten into place. Note: The rail
end (6) should be installed on top rail (2) so that the end of rail end (6) with top
and bottom set screws is facing outward. See figure 4.
ATTENTION: A minimum of two people are required for the next assembly steps.
6. Position the top rail / fixed glass assembly into place in your shower opening.
Next connect rail mount (9) to stainless steel fitting by sliding rail mount over
stainless steel fitting and tighting set screws in rail mount to secure to top rail (2).
See figure 5-1 and 5-2.
7. Slide the rail end (6) over the wall mount (7) and secure using the set screw.
See figuare 6.
8. Install the glass clamp (8) to fixed glass (3) using hardware provided. See
figure 7 for details. Flat smooth surface of glass clamp (8) should be installed
on outside of fixed glass (3).
9. Insure plastic sliding door glide is in place in underside of sliding door track
divider (10) and positioned to proper location for 10mm glass thickness. See
figure 8.
10. Position the sliding door track divider (10) into position as seen in figure 9 and
mark the 2 shower base hole positions. Note: In drawing 9 the hole locations
for attaching sliding door track divider should be 1
l
6
"
from edge of fixed
glass.
NOTE: If your surface is prone to cracking or chipping then it is recommended
that you pilot drill first using a smaller drill bit, and then step up to the final
size.
11. Using the appropriate drill bit for your base surface drill hole locations with 5/16"
diameter drill bit. Position the sliding door track divider (10) over drilled holes, and
secure sliding door track divider (10) to base using hardware in screw pack 3. See
figure 10.
12