Aston Global SEB976, Installation And Owner'S Manual, Page: 11 / 27

2. Position the top rail (2) and fixed glass (3) as shown in figure 2 and connect fixed
glass (3) to top rail (2) following the assembly sequence shown in figure 2. Note
in figure 2, one door stopper (1) should be positioned between mounting holes in
top rail (2) before connecting top rail to fixed glass.
NOTE: TOP RAIL IS ATTACHED TO THE INSIDE OF FIXED GLASS.
3. Loosen set screw on rail end assembly (6) and remove wall mount (7) from rail
end (6). Next slide the rail end (6) onto end of top rail (2) to be connected
shower wall. Loosely tighten the rail end (6) into place on top rail (2) making
sure the rail end is fully engaged on top rail. See figure 3.
4. Locate the rail mount assembly (9) and remove the stainless steel fitting and glass
connector parts from the rail mount. Loosen the set screws in rail mount and
slide onto end of top rail (2) making sure the end of rail mount which is with top
and bottom set screws is facing toward end of top rail. Loosely tighten set screws
in rail mount to secure. See figure 4-1
Next assemble the stainless steel fitting and glass connector parts to top holes in
return glass panel (5), following the assembly sequence shown in 4-2. The
stainless steel fitting should be positioned to the inside of return glass panel (5)
when complete.
5. Position the top rail/ fixed glass assembly into place in your shower. Loosen the
set screws in rail mount (9) next to glass panel (5). Next connect rail mount (9)
to stainless steel fitting by sliding rail mount over stainless steel fitting and
tighting set screws in rail mount to secure to top rail (2). See figure 5.
NOTE: THE TOP RAIL ATTACHED TO FIXED GLASS SHOULD BE POSITIONED
TO INSIDE OF SHOWER.
6. Using a level, verify the top rail (2) is horizontal and the fixed glass (3) is plumb,
mark the rail end (6) location on wall. See figure 6-2
7. Remove pre-installed screw from pre-assembled glass clamp ( 8). Position the side
of the glass clamp (8) with floor mounting hole on the floor and align with large
hole opening on bottom of fixed glass (3). Mark the mounting hole of glass clamp
(8) at this position. See figure 7
NOTE: If your surface is prone to cracking or chipping then it is recommended
that you pilot drill first using a smaller drill bit, and then step up to the final size.
8. Using the appropriate drill bit for your floor surface drill hole locations with 5/16"
diameter drill bit and install the plastic anchor from screw pack 2 into the drilled
hole for glass clamp.
10