Hanging the Door
ROLLER CAM ADJUSTMENT
Rotate the outer edge
of roller assembly usin-g---��
the small hex,
while holding the
large hex wrench --
in place.
End View
%
%
upper roller
assembly
,.
%
top rail (2)
%
=
�
bottom roller
assembly
,.
Suspend the sliding door (4) on the top rail (2). Slide the bottom edge of sliding glass door (4)
into the groove of the sliding door track divider (8). Adjust the upper roller assemblies (8) to
insure the bottom edge of sliding glass door (4) does not touch the bottom sliding door track
divider (7). See roller cam adjustment drawing for details. (The rollers for this unit have a built
in cam adjustment to adjust the plumb of sliding door. Locate the small hole in outside edge
of roller assembly and insert a small hex wrench into hole opening. Next using the hex wrench
for roller assembly slightly loosen the roller wheel assembly. Now holding the hex wrench in
place rotate the outer edge of roller assembly using the small hex wrench inserted into small
hole opening in outer edge of roller assembly. This will move the roller cam to offset any
minor adjustments for sliding door out of plumb. All 4 rollers on this unit can be adjusted as
describe above).
Install the bottom roller assemblies (8) on the sliding door ( 4) to secure the sliding glass door
( 4) to top rail (2). Adjust the bottom roller assemblies (8) to a gap of 1/32". This gap is a
starting gap, check that the sliding door rolls smoothly along the top rail. Make adjustments if
needed.
12
