Aston
®
Tire Changer ATC-5733 User’s Manual
32
www.astontechusa.com
Maintenance
6.1.1 Maintenance
◇
Prohibit unauthorized personnel for maintenance operation. To extend the service life of
the tire changer, maintenance should be performed according to the requirements of the
manual. If the machine is not maintained regularly, the operation and reliability cannot
be guaranteed, and even cause danger to the operator or the people in the vicinity of the
machine. Before any maintenance operation, circuit and gas supply device must be
disconnected, turn off the switch. In order to release the pressure of the air from the line,
it is necessary to press the pedal 3-4 times.
◇
It must be professional staff using the original spare parts do the timely replacement of
damaged parts. The safety device (safety valve, control valve) of the unauthorized
removal or replacement is a violation of state regulations on work safety. (Note: the
manufacturer is not responsible for damage caused by the parts of other manufacturer
and the damage caused by the disassembling of the safety device).
6.1.2 Tending
◇
Regular use of diesel oil to clean the turntable, to prevent the formation of dirt. Daub
lubricating oil in the skidway of the clamps.
◇
As shown in figure 15-a, control oil mist level that in the oil mist device, if the oil level
is lower, you need to unscrew the oil F, and then as figure 15-a., control oil mist level,
HG ISO and viscosity of VG32 ISO type oil mist is recommended. (like
:
ESSO Febis
K32
,
MOBIL Vacouline 1405
,
KLUBER32). when stepping the pedal 3 to 4 times,
check whether there are oil drops into the oil cup F, if not, adjust screw D.
◇
As shown in figure 15-b, 20 days after the first use of the machine, re-tighten the screw
A and B that is in the clamps.
◇
As shown in figure 15-c, machine horsepower is not enough, check the triangle belt of
the motor by the following steps: (before any operation, to cut off the power) first,
Unscrew the 4 screws on the side of the box, remove the left side protective plate of the
tire changer, second, use special adjustment screw X (Figure 15-c) that is in the motor
support base to adjust the triangle belt.