5
INSTALLATION
The underwater light kit consists of the following components:
•
Underwater Light METEOR LSR36500
•
4 x fixing screw 5.5x50 with wallplugs
•
Operating Instructions with Declaration of Conformity and Warranty conditions
The METEOR LSR36500 has to be installed on a flat surface on the pool wall under waterline.
Do not try to install the underwater pool light while the pool is filled with water.
When the installation is finished briefly test the underwater light prior to fill the pool with water.
The installation have to be realized by a qualified personnel.
Note:
•
Avoid using the underwater pool light out of the water for more than 1 minute.
The underwater pool light is protected by a temperature sensor against over-heating.
When the temperature of the underwater pool light exceeds 85°C the underwater pool light
is automatically switched off.
Wall preparation
The underwater pool light is recommended to be installed around 0.2 m below the waterline for the
best illumination and to avoid over-heating.
To fix the underwater pool light with screws 5.5x50 the diameter of holes drilled into the wall has to
be 8 mm.
The diameter of the hole for cable gland drilled through the wall has to be 10 mm.
Sealing
Before inserting the cable with gland through the hole the sealant has to be used into the grooves,
around the four fixing holes and around the gland in the rear surface of the underwater pool light.
The sealant can be on silicon basis but the best solution is two-component polymer sealant.