ASTEC RT130, Operator'S Manual, Page: 23 / 64

OPERATING INSTRUCTIONS
19 AU106984 G7B
ENGINE SPEED
Do not run the engine at low idle speed for long periods
of time. This can cause a low operating temperature.
Long periods at idle speed can cause acids and deposits
to form in the engine oil.
It is recommended that you run the engine at full throttle
when operating conditions permit and when safe.
BOOSTER BATTERY CONNECTIONS
Make sure the person making the connections is wearing
face protection.
RT130017
RT160033
1. Make sure the jumper battery is 12 volts.
2. If using another machine for power, make sure the
two machines DO NOT touch.
3. Connect the positive (+) jumper cable to the positive
(+) battery terminal (1).
4. Connect the negative (-) jumper cable to a good
frame ground away from the batteries.
5. Start the engine.
6. Disconnect the negative (-) jumper cable first and the
positive (+) jumper cable last.
PARKING AND STOPPING THE
ENGINE
1. When the work day is finished, make sure the
machine is parked on level ground. The machine must
be on level ground before you do scheduled
maintenance.
IMPORTANT: If you must temporarily park the machine
on a slope or incline, position the machine at right angle
to the slope.
2. Support or lower all attachments to the ground.
3. Set all operating controls to the NEUTRAL or OFF
position.
4. Move the engine throttle lever towards the MIN
position to decrease the engine speed to idle. Allow
the engine to reach operating temperature before
stopping. Run the engine at low idle speed for two
minutes or more, if the engine has been working at
full load. This procedure will cool the engine parts
evenly.
5. Turn the key switch to the OFF position to stop the
engine. Remove the key.
MACHINE OPERATION
WARNING:
Batteries contain acid and
explosive gas. Explosion can result from sparks,
flames or wrong cable connections. To connect
the jumper cables correctly to the battery of this
machine, see the correct method shown on this
page. Failure to follow these instructions can
cause serious injury or death.
WARNING:
Always wear face protection
when making battery connections.
1
WARNING:
Before operating, check the
machine for correct operation of the steering,
hydraulic controls, instruments, and safety
equipment. A machine that runs correctly can
prevent accidents. Make any necessary repairs or
adjustments before you operate the machine.
WARNING:
DO NOT operate the machine while
under the influence of alcohol or drugs.
WARNING:
Operate controls only when in the
operators position.