AW12 VEHICLE INSTALLATION KIT
QUICK START GUIDE
assured-wireless.com
QSGmobile2022v1
Copyright ©2022 Assured Wireless Corporation. All rights reserved. All information provided here is subject to change
without notice. Assured Wireless and the Assured Wireless logo are property of Assured Wireless Corporation.
IGNITION
B
NOT USED
BATTERY -
Antenna
To router
To vehicle power
1
Install the antennas on the roof of the vehicle. For best performance, we recommend you keep at least one
meter of separation between the antennas installed on the roof.
2
Connect the ends of the antenna cables into the four RF ports on the modem as follows:
■
PRI
port: LTE-1 cable
■
B14
port: B14 cable
■
DIV
port: LTE-2 cable
■
GNSS
port: GPS/GNSS cable
Note.
See our antenna recommendations at assured-wireless.com/products/antennas.
1
Insert the ethernet cable into the RJ-45 port labeled
PoE+
on the USB to Ethernet converter and then
connect the ethernet cable to the WAN port of your router.
2
Locate the DC power cable with the 4-pin Molex connector. Insert that connector into the port labeled
PWR
IN
on the bottom of the USB to Ethernet converter, and then connect the unterminated ends of the DC
power cable to the power source of the vehicle.
3
Refer to your router user manual for router configuration. Please make sure the MTU size setting in your
router is 1342 or as otherwise advised at
https://iotdevices.att.com/att-iot/FirstNetMTU.aspx
Note.
If there is no ignition connection, be sure to connect the orange and red leads together.
6
Install antennas
7
Connect power and Ethernet cables
