INTRODUCTION
7
GLOSSARY OF TERMS
(as used in this manual)
Alternating Current, AC:
Current which reverses direction on a regular basis, commonly in the
U.S.A. 60 times per second, in other countries 50 times per second.
Breakdown:
The failure of insulation to effectively prevent the flow of current, sometimes evident by
arcing. If voltage is gradually raised, breakdown will begin suddenly at a certain voltage level. Current
flow is not directly proportional to voltage. Once breakdown current has flown, especially for a period of
time, a repeated application of voltage will often show breakdown beginning at a lower voltage than
initially.
Conductive:
Having a volume resistivity of no more than 103 ohm-cm or a surface resistivity of no
more than 105 ohms per square.
Conductor:
A solid or liquid material which has the ability to let current pass through it, and which
has a volume resistivity of no more than 103 ohm-cm.
Current:
The movement of electrons through a conductor. Current is measured in amperes,
milliamperes, microamperes, nanoamperes, or picoamperes. Symbol =
I
Dielectric:
An insulating material which is positioned between two conductive materials in such a way
that a charge or voltage may appear across the two conductive materials.
Direct Current, DC:
Current which flows in one direction only. The source of direct current is said
to be polarized and has one terminal which is always at a higher potential than the other.
Hipot Tester:
Common term for dielectric-withstand test equipment.
Hypot®:
Registered trademark of Associated Research, Inc., for its dielectric-withstand test equipment.
Insulation:
Gas, liquid or solid material which has a volume resistivity of at least 1012 ohm-cm and is
used for the purpose of resisting current flow between conductors.
Insulation Resistance Tester:
An instrument or a function of an instrument capable of measuring
resistance’s in excess of 200 megohms. Usually employs a higher voltage power supply than used in
ohmmeters measuring up to 200 megohms.
Leakage:
AC or DC current flow through insulation and over its surfaces, and AC current flow
through a capacitance. Current flow is directly proportional to voltage. The insulation and/or capacitance
is thought of as a constant impedance, unless breakdown occurs.
Resistance:
That property of a substance which impedes current and results in the dissipation of power
in the form of heat. The practical unit of resistance is the
ohm.
Symbol =
R
Trip Point:
The minimum current flow required to cause an indication of unacceptable performance
during a dielectric voltage-withstand test.
Voltage:
Electrical pressure, the force which causes current through an electrical conductor.
Symbol =
V
Summary of Contents for Hypot II 4500D
Page 5: ...SECTION 1 OPERATORS MANUAL ...
Page 43: ...SECTION 2 SERVICE MANUAL ...
