12
BAG E
REMOVE THESE
PARTS FOR:
Steps 1-2
TOOLS USED
.050"
1:1
7368, qty 4
thin shim
1:1
7381, qty 2
set screw
6588, qty 1
black grease
7380, qty 2
MIP CVD axle
7379, qty 2
MIP CVD bone
7381, qty 2
coupling
3977, qty 4
3/16 x 3/8 ball bearing
unflanged
1:1
7381, qty 2
cross pin
1:1
1:1
7377, qty 2
spacer
7366, qty pr
hub carrier
7369, qty 2
drive pin
1:1
7368, qty 2
thick shim
1:1
6299, qty 4
E-clip
1:1
9263, qty 2
rear outer hinge pin
1:1
7383, qty 1
MIP thread lock
step 1 TEAM/FT
5
7369
7368
3977
7377
7366
7368
7380
7381
7379
7381
coupling
7381
6588
7383
thread lock
3977
9
step 2 TEAM/FT
6299
9263
6299
6466
3
hub carrier
assembly
the "L" marked
hub goes on
the left side
of the truck
TEAM/FT ONLY: MOUNT REAR HUB CARRIERS
Place the left rear hub carrier assembly and two
1/16" #6466 spacers between the holes as shown.
The spacers are on the back side of the hub carrier,
shortening the wheelbase.
Install the #9263 hinge pin through the arm and hub
carrier. Install two #6299 E-clips.
Follow steps 1 & 2 for the right side.
TEAM/FT ONLY: ASSEMBLE MIP CVD'S
Spread some #6588 Associated black grease inside the #7380 axle
hole where shown, then on the #7381 coupling. Slide the coupling into
the axle.
Slide the #7380 axle into the #7379 dogbone, aligning the cross holes.
Insert the #7381 cross pin, spacing it evenly on both sides of the bone.
Add the #7383 MIP thread lock to the #7381 set screw. Angle and turn
the CVD so the set screw can be screwed in with the Allen wrench.
Repeat steps 1-4 for the remaining CVD.
Slide two #7368
thin
shims onto the #7380 axle. Slide one
#3977 unflanged bearing onto the axle. Push the CVD
assembly into the back of the #7366 rear hub carrier.
Slide one #7377 spacer into the hub carrier from the
front followed by the second #3977 bearing.
Slide one #7368
thick
shim onto the axle.
Install the #7369 drive pin with your
needlenose pliers.
Assemble the other hub carrier.
Thread on the #6273 ball end into the
hole shown and add the #7260 nut to
the other side.
(When you do the other
hub carrier, thread the ball end into the
other side so both ball ends will point to
the front when assembled.)
Add a
#6272 dust cover to the ball ends.
6273
6272
7260
TEAM & FACTORY TEAM KITS ONLY
7260, qty 2
4-40 nut
6272, qty 2
dust cover
1:1
1:1
1:1
6273, qty 2
ball end
1:1
6466, qty 4
spacer, 1/16"
