Communicators Menu - SecureWatch Panels
This sub-menu disconnects the GSM path from
.
SecureComm
When you select the
GSM Network Scan
sub-menu, the
system searches for GSM signals in your vicinity and connects
to the strongest.
Monitor Signal
will flag a fault in the event of a GSM network
failure. By default it is set to YES.
You can delay the notification of a fault by going to the
Fault
Delay
sub-menu and keying-in a delay time in minutes. Useful
in areas of poor network coverage that are prone to occasional
brief dropouts. By default it is set to 15 minutes.
In this sub-menu you can turn off the
Tamper
signal from the
communicator. By default it is on i.e. YES.
Note:
This Tamper switch is connected to Relay 1in SecureWatch Mode. A
Tamper condition will not be reported to the Panel via the Comms Card link.
Relay 1 should be wired to a Zone programmed as Tamper or wired to a Tamper
loop on a spare Zone. Turning off this option will disable the tamper switch and
keep Relay 1 permanently closed.
The GSM unit can detect and flag attempts at jamming the GSM
signal. In areas where the network is prone to high levels of
radio noise this feature can be turned off by deselecting
Jam
Detect
Note:
If you are using a
GSM-WiFiU
via the
SecureComm
service, the
HKC
APP
can notify you - on your smartphone - if there is jamming of the
GSM/GPRS path.
SecureComm
can also notify your monitoring centre. This
feature is enabled in the
HKC APP
.
96211 GSM Status
96212 Disable GSM
96213 Options
962131 Monitor Signal
962132 Fault Delay
962134 Tamper
96214 GSM N’work Scan
962133 Jam Detect
This sub-menu offers an overview of the
SecureComm
connectivity and where you will find the
Installation ID
number.
!
!
Yes
10m
Yes
Yes
2
Disable GSM
2
Fault Delay
2
WiFi
1
Status
1
Monitor Signal
1
GSM
4
GMS Network Scan
4
Tamper
3
Options
3
Jam Detect
14
Summary of Contents for SecureComm HKC GSM-WIFI U
Page 27: ......