01/31/18
1-800-810-WIRE • www.sargentlock.com •
A7765C
13
Copyright © 2018, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
Profile Series v.S1 PoE Exit Device
Step #1 – Prepare Door
A. Verify Hand and Bevel of Door
• This device is non-handed.
• Door should be fitted and hung.
• Verify box label for size of exit device and function.
B. Door Preparation
If using a mullion, install prior to installing hardware.
Doors should be pre-prepped.
Prep door using the following (see website www.intelligentopenings.com):
• Exit installation instructions A6770
• Field Template A7992 (Wood)
• Door Manufacturer’s Template 4640 (Metal and Wood)
Note: Wood door has additional cutout if installation includes a cylinder.
Inside
Outside
Left Hand
Reverse Bevel
LHRB
Right Hand
Reverse Bevel
RHRB
Fig. 1A
Installation for Profie Series v.S1 With 8877/8878 Rim Exit Device
8
Step #2 - Position Exit Trim (ET)
For exterior applications, use ET gasket (52-0263) to seal
between ET escutcheon and outside door surface (Fig. 2A).
1A. For wood doors: Route ET wire harness through the
cylinder hole and out the other side (Fig. 2A).
1B. For metal doors: Route ET wire harness through the
cylinder hole and door.
2. Place ET trim on door.
3. Connector from ET harness connects
to connector from chassis (next step).
Fig. 2A
Showing Wood Door Template Without Cylinder Hole
ET gasket
(part number
52-0263)
Outside of Door
1
2
3
