700703 REV H 09/18
ADAEZ Wireless Interface Module
Installation and Operation Instructions
4 of 17
6
Mount and Apply Power to the WIM
The ADAEZ WIM may be powered by 12 or 24 Volts AC
or DC current. If the door operator will be powered
directly from the WIM, a 24VDC 750ma (minimum)
power supply is required.
NOTE:
2.
Provide power to the WIM.
(Refer to Figure 1)
a. If the Optional hardwire kit (p/n ADA1015P) is
used to power the WIM and door operator, plug
the provided GREEN connector into the power
port as shown.
1.
Mount the WIM enclosure in a remote location
as desired.
b. If Power supply is by others, connect the power
supply using the provided GREEN connector. If
a DC power supply is used connect the ground
to the terminal marked “-“ and the positive to the
terminal marked “+”.
c. If the operator will be powered through the WIM,
power is properly applied to the ADAEZ
operator the LED on the bottom of the battery
pack will light steady GREEN.
ADA1015C) to power the Operator. When
d. When the WIM is properly wired with power
applied LED D8 near the power connector will
light GREEN.
use the supplied Operator Wire Harness (p/n
Figure 1
INSIDE
BUTTON
INSIDE BUTTON
PRESS & RELEASE
TO LEARN
HOLD TO ERASE
OUTSIDE
BUTTON
DOOR
OPERATOR
FIRE P
ANEL
IN COM OUT
A
CCESS CTR
OUTSIDE BUTT
ON
DISABLE
LOCK
PO
WER
NO COM NC
LOCK
OUTSIDE BUTTON
PRESS & RELEASE
TO LEARN
HOLD TO ERASE
OPERATOR
SIGNAL
SIGNAL
DELAY
POWER IN
12 OR 24V
+
CH S
+
CH S
(INCLUDED)
ADA1015C OPERATOR CABLE
POWER SUPPLY BY OTHER
OR
(NOT INCLUDED)
ADA1015P
HARDWIRE KIT
12/24V
AC/DC
