“ASSA ABLOY Opening Solution Bulgaria”
Bulgaria,Varna, 9009, “P.Stainov Str.” 10
Tel. 052/ 575 101; Fax: 052/501 811
e –mail: [email protected]
http://www.mauer.bg
OPERATING MANUAL
ELECTRONIC CARD LOCK
101.132.– RFID
Frequency 13.56 МHz Mifare
Dear customers, “ASSA ABLOY Opening Solution Bulgaria” congratulates you on the purchase of Electronic card lock “Ell-cam 2” RFID
13.56MHz and greets you the choice you made. You will have opportunity to convince yourselves in a great number of its advantages:
➢
Small overall dimensions and easy mounting.
➢
Operation with all cards type „Mifare”
➢
MasterCard for the lock reprogramming and control.
➢
Low power consumption.
➢
PCB with microprocessor based on SMD technology.
➢
Emergency power supply through Micro USB.
PACAGING
1.
Lock 101.132:
a.
Permanent Users;
b.
Changing Users;
2. Screw М4х1;
3. Nut М18;
4. Cam straight;
5. Nut М8;
6. Service card;
7. Client Card;
8. Micro USB Cable;
9. Emergency power supply;
10. Operating manual;
11. Mounting instruction;
12. Template for mounting.
OPERATING INSTRUCTIONS
➢
PLEASE, READ THIS MANUAL BEFORE START LOCK OPERATION!
The lock is supplied with a knob in closed position.
DON’T
SHOW
RFID
CARD
IN
FRONT
OF
THE
ANTENNA
BEFORE
READING
ALL
INSTRUCTIONS
BELOW.
WHEN THE DEVICE IS POWER ON THE FIRST CARD SHOWN TO THE ANTENNA OF THE DEVICE WILL BE “SERVICE CARD”. KEEP THE
SERVICE CARD AND DON’T LOSE IT.
MOUNTING
Please, follow the rules in the Mounting instruction for the lock mounting. Use the mounting template to drill the fixing holes. Power the device
by placing 3xAAA batteries**. This is followed by short beep alarm and blue LED flashing on. Don’t show card during the mounting operations.
When the mounting is complete, program the service card according to the following point from this instruction. The lock is ready for operation.
PROGRAMING SERVICE CARD
1.
When the device is powered on for first time it will indicate with short red LED flash of every 4 seconds(The device is ready to
accept service card). Place the Service card in front of the antenna and you will hear a long beep signal and red LED flashing on,
followed by 3 short beeps and 3 flashes of the blue LED. Service card is programmed.
CHOOSING USER MODE
PROGRAMMING PERMANENT USER CARDS
1.
When the service card is programmed the device will indicate with flashing red and blue LED on every 1s that device will accept USER
CARDS.
2.
Place user card in front of the antenna and you will hear low and the high beep followed by red and blue LED flashing.
ATTENTION:
IF YOU TRY TO ENTER ONE CARD TWICE THE DEVICE SHALL REACT WITH RED LED FLASH.
3.
Repeat step 2 for adding maximum 50 cards.
4.
To exit the programming mode place the Service card in front of the antenna or wait for 10 seconds to exit automatically.
OPENING
1. Place the card that was programmed in previous steps, in front of the antenna. This is followed by short beep alarm and blue LED
indication. The knob shall release.
2. Within 6 seconds turn the knob in opening direction.
LOCKING
1. Place the card which is already in the memory in front of the antenna within 2 seconds. After hearing the short beep alarm and short blue
flashing, the knob shall release for locking.
2. Within 6 seconds turn the knob in locking direction. The lock shall block immediately after locking followed by short beep and blue LED
flashing on.
