7. Strike Installation
• Should the external outer pull supplied
interfere with an existing security or fly
screen door, or if there is not enough
finger room, a flat outer pull is available as
an optional extra
• Mark and drill the
ø
16mm hole (exterior)
• Drill centre hole to
ø
20mm (exterior)
• Drill centre hole to
ø
10mm (interior)
• Place cylinder with tail bar into cylinder
retainer, then place into Flat Outer Pull
• Fit Flat Outer Pull to door as per Step 5
• If using a 6-pin cylinder, mark and drill
hole to
ø
14mm as shown
• Place cylinder with tail bar into 6-pin
cylinder retainer
• Fit outer pull to door as shown in Step 5
9. Fixing Flat Outer Pull
10. Required for 6-pin cylinder assembly only
(Note: 6-pin cylinder sold separately)
Surface Fix
• Fix the strike body to the jamb with the
2x16mm screws. Do not tighten
• Close the door and adjust the strike up
or down until it is central to the handle,
then tighten fixing screws
• Once the strike body is central, fit
the strike cover and secure with the
2x7mm screws
• Check operation of lock using both the
snib and key-to-lock functions. Ensure
that the beaks engage properly with the
strike
• If further adjustment is necessary,
partially unscrew the strike plate fixing
screws. Adjust the jacking screw height
as required and re-tighten the strike
plate fixing screws
Note:
Maximum adjustment is
4mm. Do not exceed this as it
may compromise security.
8. Check Lock Operation
Note:
Arrows indicate direction of strike fixing screws.
5. MOUNTING CHASSIS
• Place the outer pull on the external face of
the door
• Ensure that the beaks of the lock chassis
are facing towards the door jamb and the
red indicator is at the top
5. Fixing Outer Pull and Lock Chassis
• Align the tail-bar through the lock chassis.
• Locate lock chassis spigots into holes
• Secure together with screws
• Either side of the chassis can be
mounted to the inside of the door
depending on door handing
Side Fix
• Place strike cover over strike body and
secure with the 2x7mm screws
• Place this strike assembly against the
door and lightly secure with the 2x16mm
screws
• Close the door and adjust the strike up or
down until it is central to the handle, then
open the door and tighten fixing screws
Sliding Door Lock
Patent: Applied
ASSA ABLOY New Zealand Limited
6 Armstrong Road, Albany, Auckland 0632
www.assaabloy.co.nz
ASSA ABLOY Australia Pty Limited
235 Huntingdale Road, Oakleigh, Vic 3166
www.assaabloy.com.au
• Place cylinder into handle and secure with
the cylinder wedge as shown
• Ensure cylinder is orientated as shown, to
match up with the slot in the lock chassis
6. Fixing Inner Handle
• Ensure the locking beaks and indicator are
retracted (unlocked)
• With the
snib down
, place the handle
over the lock chassis
• Depress the DCD button to enable the
handle to pass over
• Fix handle to lock chassis by screwing
the 2x28mm screws into the side. Do
not over tighten
Snib
Ensure snib is
down
and aligned with the
bottom of the slots in the lock chassis
Cylinder
Ensure cylinder
is installed
with the pin
chamber
facing
upward
Cylinder
Wedge
Snib
DCD
Button
6-pin Cylinder Retainer
Cylinder Retainer
ø14mm for 6-pin Cylinder
ø14mm