9. Electrically CONNECT the antenna/reader wire to the lock body.
NOTE: The antenna/reader wire connector is keyed to only fit one way.
9a. ENSURE correct orientation of the connector while inserting it.
9b. TUCK excess cable into lock body as shown.
10. INSTALL the Batteries.
NOTE: New batteries should always be used and inserted in the
correct polarity position.
10a. INSTALL the battery and battery cover.
10b. INSTALL and TIGHTEN the screws.
11. PLACE the single-door Strike Plate Template.
11a. PEEL OFF the protective layer of the Strike Plate Template
and ALIGN it to both the latch centerline and the edge of
cabinet.
11b. DRILL two pilot holes as shown on template.
11c. REMOVE the template.
10a
10b
9a
9b
Connector cable tucked in
3080076.004, Rev. B
10
