8
Post Installation/Mounting Devices
4
Note:
Tamper is disabled during initial set-up. For details on disabling tamper see Section 6
Control Unit Mounting
Wall Mounting
Using the two holes on the mounting back plate,
mark the position of the holes. Drill two holes and
fix with the screws and plugs provided. Hook the
control panel onto the plate. Ensure that the control
unit is fitted at approximately chest height where
the display can be easily seen and the keypad
convenient to operate.
•
The control unit tamper protection will
automatically arm when mounted on the back
plate.
NOTE: At this point, the control panel
screen should be showing:
mount devices,
see manual
Mounting other devices
Find a location where the device is to be mounted,
see section “Location Planning” for suggestions.
Before proceeding to mount the devices physically,
check that the control unit will receive the system
radio transmissions by doing a simple radio range
test.
Please make sure the control unit screen is
displaying:
mount devices,
see manual
Hold the devices in the desired location and press the
Test/Learn button (see below) on the accessories.
•
KEYPAD:
press arm button.
•
ALL OTHER DEVICES:
Hold the device in the
desired location and press the learn/test button,
the control unit should respond with a chime.
If the sensor signal reached the control unit, the
screen will briefly display:
dc zone01 b 6
........
*Note: this screen shot is use as example only.
The radio signal strength is shown by a number on
the upper right (6 in this case). this number ranges
from 1 to 9 (strongest). Where possible please ensure
sensor shows 3 or above for optimal performance.
When you are happy that all your devices can
communicate with the panel, press the Green
“Disarm” button and enter your pincode that you
previously defined. The screen will now show:
Alarm Off
00:00 01 jan
Leave it at this screen and proceed to mounting the
accessories as detailed below. The fault light/beep
maybe activating periodically and you can ignore that
until you finish mounting.
Mounting the siren
Ensure the tamper switch is fully depressed when
the siren is mounted. If there is a gap, pack with a
suitable spacing material.
Round
Siren
Base
Wall
Spring Guide
Spring compressed
firmly against wall
1
Using the large screws and wall plugs provided,
screw the siren onto the wall through the 4
mounting holes on the siren base.
2
Fix the siren cover with the securing screw.
Mounting the PIR
1
Open the PIR by loosening the bottom screw.
Knock out the relevant holes on the base where
the plastic is thinner. The center two knockout
holes are for flat wall mounting while the 4 side
holes are for corner mounting.
