4
MP6600 Series Multi-Point Lock
Installation Instructions
Used with VN1 Escutcheon Trim and V Series Indicators
FM556 08/20
Copyright © 2020, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected]
4
Rehanding Indicator (if required)
Verify hand and bevel of door. See Figure 2 below.
LH
Left Hand
Hinges Left
Open Inward
LHRB
Left Hand
Reverse Bevel
Hinges Left
Open Outward
RH
Right Hand
Hinges Right
Open Inward
RHRB
Right Hand
Reverse Bevel
Hinges Right
Open Outward
Note:
Stand outside of locked door when determining door hand.
Next, verify inside and/or outside indicators are handed
correctly, using Spindle Cam Position chart. (Figure 3)
If they are handed correctly, skip to Step 5
"
Prepare Door".
If they are not handed correctly:
1. Remove indicator back plate by pulling out from top slot,
then remove spindle cam from assembly. (Figure 4)
2. Position spindle cam in correct direction for door
hand. (Figure 3)
Important:
•
For thumbturn indicators, make sure thumbturn is
positioned in 12 o’clock direction as shown. (Figure 5)
3. Slide spindle cam post into the correct slot of the
display slide. (Figure 4)
4. Re-seat back plate into original position.
5. Return indicator to
v
acant/unlocked position for installation
Door Hand: RH / RHRB
Door Hand: LH / LHRB
Outside Indicator
Inside Indicator
Inside Indicator
Outside Indicator
Spindle Cam Position for Locks with Deadbolt (*and 56 function)
Door Hand: RH / RHRB
Door Hand: LH / LHRB
Outside Indicator
Inside Indicator
Inside Indicator
Outside Indicator
Spindle Cam Position for Locks without Deadbolt (*except 56 function)
Figure 2
Figure 3
Spindle
cam
Display
slide slot
Plate slot
for removal
Back plate
Thumbturn
position
Figure 4
