6
ED8200A Series
Installation Instructions
Fire-Rated Rim Exit Device
FM124B 04/20
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected]
Copyright © 2011, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
b
Install Strike
Install strike using flat head machine screws in
holes marked
A
. (Figure 7) Adjust strike. Strike is
properly adjusted when latch is able to fully project
when door is closed. Drill, tap, and install two (2) flat
head machine screws in holes marked
B
. (Figure 7)
Tighten all screws.
c
Install Front Bar Insert, Rear & Front Covers
A. Slide front bar insert over end of front bar.
B. Assemble 1/2" pan head tapping screw through insert mounting hole.
C. While holding insert flush against back edge of front bar, tighten screw to bottom of recessed
mounting hole.
D. Install front and rear cover using 1" flat head screw with attached washer. (Figure 8)
Figure 8
Flat Head
Machine
Screw
1" Flat Head Screw
with Attached Washer
1/2" Pan Head Tapping Screw
Front
Cover
Back
Edge
Assembled View
Front Bar
Front Bar
Front Bar Insert
Front Bar
Insert
Rear
Mounting
Bracket
Rear Cover
Rear Cover
Figure 7
Flat Head
Machine
Screw
Strike
Shim
Door
A
A
B
B
