5
ED8200A Series
Installation Instructions
Fire-Rated Rim Exit Device
FM124B 04/20
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected]
Copyright © 2011, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
4
Installation
a
Mount ED8200A Exit Device
Installation of device depends on trim:
A. For Reinforced Metal Doors:
•
For throughbolted trim
in 2-1/8
"
prep, install device with two (2) fillister head screws (packed
with trim) in latch assembly holes marked
D
. (Figure 6)
For all other applications
, install device with two (2) pan head machine screws and two (2)
internal tooth lock washers in latch assembly holes marked
C
.
• Use level as shown to ensure device is level. Use rear bracket to spot, drill, and tap two (2) rear
bracket mounting holes. Attach rear bracket to door using two (2) pan head machine screws and
two (2) lock washers. Drill, tap, and install four (4) flat head machine screws in latch assembly
holes marked
E
. (Figure 6)
B. For Un-Reinforced Doors Only:
• Using device as a template, drill 1/4
"
(6 mm) top and bottom latch assembly holes marked
D
though door. Enlarge holes to 3/8
"
(10 mm) from opposite side of door to clear for sex nuts. Install
two (2) flat head machine screws and two (2) sex nuts. Drill and tap two (2) middle latch assembly
holes marked
E
and install two (2) flat head machine screws (if applicable). (Figure 6)
C. For All Other Door Types:
•
For throughbolted trim
in 2-1/8
"
prep, install device with two (2) fillister head screws (packed
with trim) in latch assembly holes marked
D
. (Figure 6)
For all other applications
, install device with two (2) pan head machine screws and two (2)
internal tooth lock washers and two (2) sex nuts in latch assembly holes marked
C
.
• Use level as shown to ensure device is level. Use rear bracket to spot and drill 1/4
"
(6 mm) holes
through door. Enlarge holes to 3/8
"
(10 mm) from opposite side of door to clear for sex nuts and
bolts. Attach rear bracket to door using two (2) pan head machine screws, two (2) lock washers,
and two (2) sex nuts. (Figure 6)
Figure 6
Sex Nuts
Level
Rear
Bracket
Lock
Washer
Pan
Head
Machine
Screw
Flat Head Machine Screw
Of Device
Stop Line
Latch
Assembly
E
C
C
D
D
E
E
E
Sex Nuts
IMPORTANT
Maintain a 1/16" (2 mm) gap
between stop and latch frame.
