2 1
2 1
2 1
2 1
2 1
2 . 6
2 . 6
2 . 6
2 . 6
2 . 6 ASRock Smart Remote Installation Guide
ASRock Smart Remote Installation Guide
ASRock Smart Remote Installation Guide
ASRock Smart Remote Installation Guide
ASRock Smart Remote Installation Guide
ASRock Smart Remote is only used for ASRock motherboard with CIR header. Please
refer to below procedures for the quick installation and usage of ASRock Smart Remote.
Step1.
Find the CIR header located next to
the USB 2.0 header on ASRock
motherboard.
Step2.
Connect the front USB cable to the
USB 2.0 header (as below, pin 1-5)
and the CIR header. Please
make sure the wire assignments and
the pin assignments are matched
correctly.
Step3.
Install Multi-Angle CIR Receiver to
the front USB port. If Multi-Angle CIR
Receiver cannot successfully receive
the infrared signals from MCE
Remote Controller, please try to
install it to the other front USB port.
1 2
4
3
5
USB 2.0 header (9-pin, blue)
CIR header (4-pin, white)
3 CIR sensors in different angles
1.
Only one of the front USB port can support CIR function. When
the CIR function is enabled, the other port will remain USB
function.
2.
Multi-Angle CIR Receiver is used for front USB only. Please do
not use the rear USB bracket to connect it on the rear panel.
Multi-Angle CIR Receiver can receive the multi-direction
infrared signals (top, down and front), which is compatible
with most of the chassis on the market.
3.
The Multi-Angle CIR Receiver does not support Hot-Plug
function. Please install it before you boot the system.
* ASRock Smart Remote is only supported by some of ASRock motherboards. Please refer to
ASRock website for the motherboard support list: http://www.asrock.com
USB_PWR
P-
P+
GND
DUMMY
ATX+5VSB
IRRX
IRTX
GND
