ASROCK ALIVENF6P-VSTA, Installation Manual

Page: 14 / 185

1 4 1 4
1 4 1 4 1 4
ASRock ALiveNF6P-VSTA Motherboard
EnglishEnglishEnglishEnglishEnglish
the red-striped side to
Pin1
2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors
2.6 Onboard Headers and Connectors 2.6 Onboard Headers and Connectors
2.6 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper
caps over the headers and connectors will cause permanent dam-
age of the motherboard!
•
Floppy Connector
(33-pin FLOPPY1)
(see p.2 No. 18)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.2 No. 7)
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors These four Serial ATAII (SATAII)
(SATAII_1 (PORT0): see p.2, No. 11)
connectors support SATAII
(SATAII_2 (PORT1): see p.2, No. 12)
or SATA hard disk for internal
(SATAII_3 (PORT2): see p.2, No. 13)
storage devices. The current
(SATAII_4 (PORT3): see p.2, No. 14)
SATAII interface allows up to
3.0 Gb/s data transfer rate.
-
connect the black end
to the IDE devices
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
SATAII_1 (PORT0)
SATAII_2 (PORT1)
SATAII_3 (PORT2)
SATAII_4 (PORT3)
Serial ATA (SATA) Please connect the black end of
Power Cable SATA power cable to the power
(Optional)
connector on each drive. Then
connect the white end of SATA
power cable to the power
connector of the power supply.
Serial ATA (SATA) Either end of the SATA data cable
Data Cable can be connected to the SATA /
(Optional)
SATAII hard disk or the SATAII
connector on the motherboard.
connect to
the power
supply
connect to the SATA
HDD power connector