ASROCK ALIVENF5SLI-1394, Installation Manual

Page: 20 / 228

2 0 2 0
2 0 2 0 2 0
ASRock ALiveNF5SLI-1394 Motherboard
EnglishEnglishEnglishEnglishEnglish
2.7 Onboard Headers and Connectors 2.7 Onboard Headers and Connectors
2.7 Onboard Headers and Connectors 2.7 Onboard Headers and Connectors
2.7 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
•
Floppy Connector
(33-pin FLOPPY1)
(see p.2, No. 25)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE Connector (Blue) Secondary IDE Connector (Black)
(39-pin IDE1, see p.2 No. 11) (39-pin IDE2, see p.2 No. 10)
Note: If you use only one IDE device on this motherboard, please set the IDE
device as “Master”. Please refer to the instruction of your IDE device vendor
for the details. Besides, to optimize compatibility and performance, please
connect your hard disk drive to the primary IDE connector (IDE1, blue) and
CD-ROM to the secondary IDE connector (IDE2, black).
Serial ATAII Connectors These four Serial ATAII (SATAII)
(SATAII_BLACK (PORT 1.0):
connectors support SATA data
see p.2, No. 12)
cables for internal storage
(SATAII_ORANGE (PORT 1.1):
devices. The current SATAII
see p.2, No. 13)
interface allows up to 3.0 Gb/s
(SATAII_BLUE (PORT 2.0):
data transfer rate.
see p.2, No. 15)
(SATAII_RED (PORT 2.1):
see p.2, No. 14)
connect the black end
to the IDE devices
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
SATAII_RED (PORT 2.1) connector can be used for internal storage
device or be connected to eSATAII_TOP connector to support eSATAII
device. Please read “eSATAII Interface Introduction” on page 26 for
details about eSATAII and eSATAII installation procedures.
SATAII_BLUE
(PORT 2.0)
SATAII_RED
(PORT 2.1)
SATAII_BLACK
(PORT 1.0)
SATAII_ORANGE
(PORT 1.1)
the red-striped side to Pin1