12
13
OPERATING YOUR LIFT CHAIR
INSTALLATION OF BACK-UP BATTERIES
2 x 9 Volt back-up batteries will lift the chair from the reclined position to the seating position
one cycle
in case of a power failure. If a power failure occurs and the chair is cycled, the 2-9 Volt
batteries will need to be replaced.
1. Removed the sliding door on
the side of the transformer to
locate the 2 - 9 Volt batteries
2. Pull out the 2- 9 Volt batteries
and replace with new batteries
3. Replace door on the
transformer
4. Batteries not included
TROUBLESHOOTING
PROBLEM
POSSIBLE FACTORS
SOLUTIONS
The chair doesn’t recline
or lift
The transformer may not
be connected
Check the power supply
has been correctly
connected to the socket
and confirm the wire from
chair to transformer is
firmly connected
The headrest or lumbar
doesn’t work
The headrest or lumbar
motor may not be
connected
Check the headrest and
lumbar motor has been
correctly connected to the
socket
The headrest and lumbar
work oppositely
The headrest and lumbar
motor plug
Check the headrest and
lumbar motor has been
correctly connected to the
socket
The hand control doesn’t
work
The hand control may not
be connected
Check the hand control
cord has been correctly
connected to the socket
