Quick-start Operations Checklist:
1) Ensure seawater-intake ball valve is open.
2) Make sure the control is powered off.
3) Turn on the air conditioner circuit breaker. If
the seawater pump has it’s own circuit breaker,
turn that on also.
4) Turn the control ON.
5) Press the Fan button. Verify that the fan is
running and that there is steady airflow out of
the supply-air grille.
6) Select a temperature set point lower than
the current cabin temperature. This starts the
compressor and seawater pump.
7) Check for a steady solid stream of water
from the overboard discharge.
8) Verify that there is a steady airflow out of
the supply-air grille.
For more specific operation instructions, see
your AC Unit owners manual for further detail.
The unit is located under the sink.
A/C UNIT
The vents are located in the salon, at the
dash and in the master stateroom. Do not
block the flow as this will overheat the
unit and cause it to shut down. There is a
boost fan for defrosters. It can be
switched on at the DC panel to the left of
the helm. We have found that at times it
may shut off after 4
–
6 hours on the
lowest flow setting. To reset, trip the
constant hot power breaker in the engine
room and then turn breaker back on.
Note:
If a vent is not flowing, remove the
grill and twist the inside valve open.
15
Summary of Contents for C 100
