Aspen C 100, Owner'S Manual, Page: 14 / 60

WALLACE 30D HEATER
The Wallace furnace control is located to
the left of the helm. To turn on, push
toggle switch to right and rotate fan-heat
control knob to desired level. The
controller has no thermostat due to size of
space heated.
The unit is located under the sink. Note:
When first warming up, it may howl for a
few moments; adjust speed to stop.
During its first operation, it may time out
as the fuel pump did not prime, -restart
unit.
The vents are located in the salon,
at the dash and in the master
stateroom. Do not block the flow as
this will shut the unit down from
overheating. There is a boost fan for
defrosters, switch it on at DC panel
to left of helm. We have found at
times on the lowest flow setting it
may shut off after 4-6 hrs. To reset,
trip the constant hot power breaker
in the engine room and then reset
breaker on.
Note: If a vent is not flowing, pop grill
off, twist valve inside open.
14