2
SlimScan BT Full Manual
Quick installation for busy people
Your SlimScan BT has already been configured for you by ASP. To
connect it to your PC, just follow the steps below:
1.
Connect the USB interface cable to the cradle cable (see page 6). Do
not connect the other end to your PC yet.
2.
Connect the power supply to the cradle cable and plug it into the
mains. The indicator on the cradle will light up red for a second or
two.
3.
The indicator on the cradle will then begin flashing blue, indicating
that the cradle is trying to pair with the scanner.
4.
Put the scanner into the cradle (see page 7). The following will
occur:
a.
The cradle indicator will light up red briefly, then return to
flashing blue.
b.
The green indicator on the scanner will light briefly and then
go out again.
c.
The scanner will sound a short high beep.
d.
The blue indicators on the scanner will flash in sequence.
e.
The green indicator on the scanner will light again.
f.
The scanner will beep.
g.
Finally, the cradle indicator will show continuous blue,
indicating that the scanner and cradle are paired.
5.
The scanner may now start sounding two quick high beeps every few
seconds – this just means that the batteries are low and need
charging.
6.
Press either of the buttons on the cradle indicator. The cradle
indicator will show red briefly, then return to blue. The red indicator
on the scanner will light, signalling that the scanner battery is being
charged.
7.
Plug the USB cable into your PC, then wait a few seconds for your
PC to detect the new USB connection and load the drivers.
Your SlimScan BT is now ready to scan! You can use it as a hands-free
scanner right away, but you should wait at least a few hours for the
batteries to charge before using it as a cordless scanner.
In the rest of this manual, we’ll describe the features of the scanner and
configuration options in detail.
Summary of Contents for SlimScan BT
Page 2: ......
