11
310749
13.When paint starts to come out of prime
tube, pull and hold gun trigger, and turn
Spray/Prime valve to SPRAY.
When paint comes out of gun, release
trigger.
Priming
– Oil–based or Water–based Materials
14.Attach prime tube to suction tube.
15.Proceed to Spraying Operation, page 15.
NOTE:
Motor stopping indicates pump and
hose are primed with paint.
pull and hold trigger
paint
Release trigger
SPRAY
WASTE
ti3586a
ti3586a
prime
tube
suction
tube
Pump Check Valves
Storing pump in water, inadequate flushing, or
ingested debris can cause either of the pump’s
two check valves to malfunction. If the pump
does not prime after 30 seconds, try to jar the
check balls loose by tapping the inlet valve with
a small wrench as the sprayer is on and running.
HINT:
To determine if the inlet valve ball is sticking, unscrew inlet valve from pump and check it.
If sprayer continues to cycle (motor and pump run) after you release gun trigger, the pump valves may be
obstructed or worn. If they are worn, Valve Repair Kits are available. Consult an authorized service
center.
tap here
9564C
CAUTION:
Excessive shock will fracture or cause
other damage to the pump.
Summary of Contents for 248772 A series
Page 29: ...29 310749 Notes ...
Page 33: ...33 310749 Notes ...
