PAGE 2
User Manual PS 10 / August 2016 © ASL Intercom BV
1.0
GENERAL DESCRIPTION
The PS 10 is a single channel analog intercom
station
for “Listen Only” purposes. It is often used
as an IFB Receiver. The unit is housed in a
strong metal case provided with a metal belt clip.
On the front panel are a Volume (listen level)
control and a mini jack connector to connect a
headphone or earpiece.
On the rear panel is an XLR-3 connector for the
intercom connection cable (the party line).
By applying low noise / high speed op-amps, a
propriety speech presence filter and a high power
headphone amplifier, communication is very
comfortable even in environments with a high
level of background noise.
2.0
UNPACKING
After unpacking the unit please inspect for any
physical damage and retain the shipping carton
and relevant packing materials for use should the
unit need returning.
If any damage has occurred, please notify your
dealer immediately so that a written claim can be
initiated. Please also refer to the warranty section
of this manual.
3.0
INSTALLATION
Connecting the PS 10 to an intercom system is
straightforward. The necessary DC voltages are
derived from the intercom master station or
power supply, via the intercom connection cable.
Use professional flexible microphone cable with 2
wires and 1 shield only.
Connect this cable to the LINE connector on the
rear panel of the PS 10. The unit is fully protected
against wiring mistakes (reverse power) or short
circuit in the interconnecting cables.
4.0
WARRANTY
This unit is warranted by ASL to the original end-
user purchaser against defects in workmanship
and materials in its manufacture for a period of
12 months from date of shipment to the end-user.
Faults arising from misuse, unauthorized
modifications or accidents are not covered by this
warranty.
If the unit is faulty it should be sent, in its original
packing, to the supplier or your local ASL dealer,
shipping costs prepaid. A note must be included
stating the fault(s) found and a copy of the
original suppliers invoice.
5.0
FRONT PANEL CONTROLS
1
VOLUME control knob
With this knob the listen level for the headset
or earpiece is adjusted
2
Mini Jack connector
To connect a headphone or earpiece
Pin assignment:
Tip:
Ring: Phones -
Fits both stereo and mono headphones
6.0
REAR PANEL CONNECTORS
3
LINE connector (XLR-3)
To connect the PS-10 to the intercom party line.
Pin assignment:
Pin 1: 0V / ground shield
Pin 2: +30V DC power wire
Pin 3: audio wire
