ASL INTERCOM MPS Series, Configuration Manual

Page: 35 / 60

MPS-Series – Configuration Guide
U-0664-0265.doc – Issue: 03 complete, approved
Page 35 of 60
4.6.6 Cancel All DVAs Button (DAU, VAR8, ACU and VAR8-ACU only)
Menu: Config
Æ
System
Æ
Router
Æ
Inputs
Æ
Mic/Line
Æ
< I/P # n – name >
Æ
Paging Microphone >
Æ Buttons Æ Zoning Æ < Button # nn > Æ Cancel-All-DVAs
The button function is ‘stop all DVAs’. Pressing the button stops DVAs playing to any zone. The
announcement will stop playing immediately, or play until its end depending on how the DVA is configured.
Note that contact DVAs, i.e., activated by Fire Panel, are not affected by the activation of this button
Configure a button for ‘Cancel All DVAs’ as required.
4.6.7 All Call Button
VAR4/12/20 Menu: Configuration Æ System Æ Router Æ Inputs Æ Mic/Line Æ < I/P # n – name >
Æ < Zoned Fire or Paging Microphone > Æ Buttons Æ Zoning Æ < Button # nn > Æ AllCall
ACU/VAR8-ACU Menu: Config Æ System Æ Router Æ Inputs Æ Mic/Line Æ < I/P # n – name >
Æ < Zoned Fire or Paging Microphone > Æ Buttons Æ Zoning Æ < Button # nn > Æ AllCall
The button function is ‘select all zones’. When the button is pressed, all outputs, which have been configured
as being affected by any zone selection buttons on the microphone, are selected for broadcast from the
microphone, i.e. the button press has the same effect as if all zone selection buttons on the microphone
have been pressed. Pressing a zone selection button will remove the zones associated to this button from
the selection. Any button may be configured as an All-Call button. However, only one All-Call button is
allowed on a single microphone.
Configure a button for ‘All Call’ as required.
4.6.8 Common Routing Parameters
4.6.8.1 Trigger Mode
Menu: Configuration Æ System Æ Router Æ Inputs Æ Mic/Line Æ < I/P # n – name > Æ Paging Microphone >
Æ Buttons Æ Zoning Æ < Button # nn >
Æ DVA Routing or Play DVA or Single DVA route Æ Control Æ Latching Æ Mode
System default configuration: ‘Not Latched’
Configure how the route will be triggered:
•
‘Not Latched’ mode
The first press of a ‘DVA Routing’, ‘Play DVA’ or ‘Single DVA’ button initiates a route, and a second
press terminates it.
Example is for non-emergency DVA broadcast.
•
‘Latched’ mode
This mode needs a reset button. Pressing a ‘DVA Routing’, ‘Play DVA’ or ‘Single DVA’ button initiates a
route; and pressing the associated reset button terminates it.
Example is for emergency DVA broadcast.
Program the reset button specified in the system design documentation via the following menu option.