20
Troubleshooting
The machine will not start
Check
• that the door is properly closed.
• that the main power switch is on.
• that the Delayed Start option has not been
selected. To cancel Delayed Start, press the
Stop button for three seconds.
• that the plug is connected.
• that the main fuses have not blown.
• that the overheating cut-out has not been
triggered.
The machine loses all power during a
programme
The overheating cut-out shuts off the tumble
dryer if the temperature is too high, e.g. because
dust is clogging the lint filter.
•
Clean the lint filter.
• Check also that the condensed water
container is not full and, if necessary, clean
the condenser.
See the Care and cleaning chapter.
• Wait until the machine has cooled then try
starting it. If it still does not start: Call the
service division.
Drying takes too long
•
Check that the lint filter is not blocked. See
the Care and cleaning chapter.
• Empty the condensed water container and
check that the condenser is not blocked. See
the Care and cleaning chapter.
• Overly long drying times may also be due to
the tumble dryer being located in a confined
area or in a room that is too small, causing
the air to become too hot.
• Make sure that the tumble dryer has access
to more cold air, open doors and/or windows,
for example.
Error messages
• If Over Flow appears on the display, the
condensed water container is full. Empty the
container and restart the machine.
• Read Drying takes too long in this chapter if
Max program time appears on the display.
• If Clean Lint Filter appears on the display,
clean the lint filter.
• If Clean condenser appears on the display,
clean the condenser. See the Care and
cleaning chapter.
• Call the service division if Thermistor fault
appears on the display.
• Press the Stop button to close any error
messages.
Summary of Contents for T794C
Page 27: ...27 Notes...
