The machine will not start
Check
• that the door is properly closed.
• that the main power switch is on.
• that the Delayed Start option has not been
selected. If so, the time remaining until start
will be shown in full hours on the display (e.g.,
5, 4, 3h). To cancel Delayed Start, press the
Start/Stop button for 3 seconds.
• that any plug is connected.
• that the fuses (circuit breakers) in your house
are intact. Flip the dryer breaker off and then
back on to make sure. You can not always tell
from the outside if the circuit breaker has
tripped.
• that the overheating cut-off has not been
triggered (see below).
Overheating cut-off
The overheating cut-off shuts off the tumble dryer
if the temperature is too high, caused by lint
clogging the lint filter, for instance.
• Clean the lint filter.
• Check that the condenser is clean. Clean it if
necessary. See the "Care and cleaning"
chapter.
• The overheating cut-off will reset automatically
once the machine has cooled down.
Drying takes too long
• Check that the lint filter and the condenser are
not blocked. See the "Care and maintenance"
chapter.
• Prolonged drying times may also be due to the
tumble dryer being located in a confined space
or room that is too small, causing the air to
become too hot.
• Make sure that the tumble dryer has access
to more cold air, open doors and/or windows.
The laundry does not dry, or is too
dry
• The door has been opened while the program
is running, which disrupts the moisture
monitoring function.
Error messages
If F30 is flashing on the display, the maximum
permitted program time has been reached. Check
that the lint filter and the condenser are not
blocked. See the "Care and cleaning" chapter.
Customer Care Center
1-800-898-1879
16
www.askousa.com
Troubleshooting
