13
Dishwashers with water softeners:
Salt
container
cover
The salt container in machines fitted with water softeners
must be prefilled with water then salt before the machine is
used for the first time. Use coarse salt or salt specially
intended for use in dishwasher water softeners.
The indicating lamp on the panel flashes if the machine is
out of salt. NOTE! After refilling with salt, it may take a
while before the indicating lamp goes out.
If the indication does not function, the float under the cover
may have got stuck in the salt residues. Push it upwards
and downwards to loosen it.
Unscrew the cover of the salt container, as shown in the
picture. Insert the funnel, supplied with the dishwasher, into
the top of the salt container and fill with salt. Wipe off any
spilled salt, so that the cover will seal properly, and replace
the cover.
Any salt spilled in the machine must be rinsed away
immediately. This can best be done by running a complete
programme. For this reason, it is recommended that salt be
filled into the machine just before using it to wash up.
Topping up with salt
Adjusting the salt dispenser
If the water in your area is very hard, it may be necessary to alter
the amount of salt required.
1. Press
5 times within 15 seconds. Then you get into
the changing programme. The last programmed water hardness
setting is showed by the lamps.
2.
Press
for a water hardness of
0–9
°dH
"
"
"
"
10–14 "
"
"
"
"
15–19 "
"
"
"
"
20–24 "
"
"
"
"
25–34 "
"
"
"
"
35–49 "
"
"
"
"
50–70 "
The change will remain till a new change is made.
If no change is made within 2 seconds, the machine will revert to the main
programme.
The indicating
lamps show:
The display shows:
1
2
3
4
5
6
7
