10
Too little water in the machine?
The water level is correct when it reaches up to the marking of the lower
spray pipe bearing, see picture.
If there is insufficient water in the machine, it may be because the supply pressure
is too low. This can be compensated for by altering the admission time.
1. Press
five times within 15 seconds to get into the water level modification
programme.
2. Press
to get the normal inlet time
to get 25 % increase
to get 50 % increase
to get 100 % increase
to get 150 % increase
to get 200 % increase
1
2
3
4
5
6
Display shows
If you have a longer outlet hose or if there by other reason is a too short time for the
machine to pump out the water, the pumping-out time can be changed. Do like this:
1. Press
5 times within 15 seconds. Then you get into the changing programme.
2. Press
to get an outlet time of
20 seconds
Press
"
"
25
"
Normal time
Press
"
"
35
"
Press
"
"
45
"
Press
"
"
85
"
How to set the pumping out time
20
25
35
45
85
The display window...
The displaywindow has four functions. It can show the temperature, the fault indication, the remaining
programme time and the re-programming.
...shows how much programme time remains
When a programme starts, the display shows the length of time it took when it was last run. As the
programme proceeds, the display counts down, showing the time remaining. Times can vary slightly
from one time to another, due tovariations in the incoming water temperature etc.
As the time proceeds, the time is counted down and the estimated time remaining is displayed . If the
time exceeds 60 minutes, the display alternates between the number of hours, followed by h, and the
number of minutes: e.g. 1h–25–1h–25, which says that 1 hour and 25 minutes remain of the
programme.
