ÖVRIGT
FUNCTIONAL DESCRIPTION
Åskluft's ozone generators generate ozone by elect-
rical discharges converting the oxygen in the air to
ozone. Ozone, in turn, is a highly reactive gas that
reacts with, and oxidise the substances that produce
bad odours. The ozone that is not consumed in this
process decomposes on its own and eventually rege-
nerates into oxygen. It should be expected that this
process will take at least two hours.
The electrical discharge takes place against insulators
in the form of ceramic plates. In all our models, these
tiles have a long service life, about 8 000 hours.
PRODUCT WARRANTY
Åskluft's ozone generators are of high quality, and
we guarantee their function for 3 years from the date
of purchase for its original buyers. If errors still occur
within this period, Åskluft will remedy these errors.
Depending on the nature and extent of the defect, this
can be done either by repair or by replacing a new
corresponding item.
The warranty only applies to products that have not
been subjected to careless use, misuse, modifica-
tions, accidents, failure to perform maintenance that
is specified in the operating instructions, normal wear
or repairs not performed by an authorized repairer. All
other warranties are excluded. Åskluft is not respon-
sible for consequential damage to person or property,
other than what is regulated by law.
CERTIFICATION
Åskluft is CE marked and complies
with the R & TTE Directive (1999/5 / EC),
the EMC Directive (2004/108 / EC), and
the LVD Low Voltage Directive (2006/95
/ EC) issued by the EU Commission.
Directive 2002/95 / EC (RoHS)
prohibits the use of mercury, cad-
mium, lead, hexavalent chromium
and
the flame retardants PBB and PBDE in
new electrical and electronic products
placed on the market from 1 July 2006.
EU Directive 2012/19 / EU (WEEE) on is
taken from producer responsibility.
The product must be collected
separately and must not be disposed
of in normal waste.
CONTACT US:
[email protected] +46(0)70-642 43 11
* The fuse is located in a holder just below the electrical outlet. Use a small screwdriver or similar to push out the holder. A replacement
fuse is included and is also stored in the holder. If you need a new fuse, you will find the specification in the technical description in this
manual. If you are unsure of how to make the fuse change, please contact us at Åskluft.
PROBLEM
POSSIBLE CAUSE
SOLUTION
Power cable not
Check that the power cord is
The mashine does not start
connected correctly
connected correctly
The fuse has blown
Replace the fuse*
The display doesn't light up
The mashine has not started
Press Power
Reduced capacity
The ozone plates are dirty or
consumed
Contact Åskluft
The mashine does not work
The ozone plates are consumed
Contact Åskluft for replacement
10
