background image

Canada. Industry Canada (IC)   

This device complies with RSS210 of Industry Canada.   

 

CAUTION: 

Exposure to Radio Frequency Radiation. The installer of this radio equipment 

must ensure that the antenna is located or pointed such that it does not emit RF field in excess of 

Health Canada limits for the general population. Consult Safety Code 6, obtainable from health 

Canada’s website www.hc-sc.ca/rpb.   

1. This Transmitter must not be co-located or operating in conjunction with any other antenna or 

transmitter. 

2. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled 

environment. 

3. Any changes or modifications (including the antennas) made to this device that are not expressly 

approved by the manufacturer may void the user’s authority to operate the equipment. 

This device is intended only form OEM integrators under the following conditions: 

1) The transmitter module may not be co-located with any other transmitter or antenna. 

IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop 

configurations or co-location with another transmitter), then the FCC authorization is no longer considered 

valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be 

responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC 

authorization. 

 

End Product Labeling 

The final end product must be labeled in visible area with the following: 

Contains TX FCC ID: H8N-WLU6120; IC: 1353A-WLU6120 

 

End Product Manual Information 

The user manual for end users must include the following information in a prominent location   

"IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna must not be 

co-located or operating in conjunction with any other antenna or transmitter. 

Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this 

device must accept any interference, including interference that may cause undesired operation of the 

device. 

 

Summary of Contents for WLU6120-D01








Reviews: