Asist 8595572109449, Original Operating Manual

Page: 51 / 85

Possible defects
The following problems can occur during operation:
Disorder Possible reasons Problem solving
Pump
running but not
pumping water.
1. After commissioning, the
body of the waterworks is not
yet full of water.
2. Insufficient tightness of the
supply line.
3. The non-return valve is
blocked.
4. The suction basket is not
submerged
5. The exhaust pipe air is not
discharged because the water
outlet is closed.
6. Suction cant (> 8 m).
1. Fill the device with water.
2. Check the recommended, used parts and com -
ponents of the device, such as the supply pipe
connection, drain pipe connection, connecting
ring, supply pipe, etc., as well as the screw thread
sealing strip made of zteflon or hemp rope.
3. Clean the filter and the basic supply line valve.
4. When the device starts to suck, open the water
outlet (eg tap, spray nozzles, etc.).
5. Reduce the suction height.
6. Check the water level inside or in the water
tank.
The electric motor
hums but does not
work.
1. It has no power supply.
2. The fan cover prevents
rotation.
3. Blocked pump or damaged
motor
1. Check the power supply.
2. Pull out the plug, remove the fan cover with a
screwdriver, then reattach it. Gently turn the blade
and check that it moves without obstruction.
3. If it is blocked, send the device to an author -
ized service center.
Insufficient water
is leaking.
1. Suction height (> 8 m).
2. The suction basket is
blocked.
3. Dirt has reduced the effective
performance of the equipment.
1. Check the suction head.
2. Clean the filter.
3. Immerse the suction basket in deep water.
The heat-sensitive
switch does not
switch off the
device.
1. The pump is overloaded
because there is dirt in it
1. Clean the pump.
2. Send the device to an authorized service
center for inspection.
Frequent switch -
ing on and off of
the device switch.
1. There is no compressed air
in the tank.
1. Use a suitable valve and fill the tank with
compressed air at a pressure of 1.5 bar using
compressed air.
51