Operating Manual - digiMIX18 Digital Mixer
14
4 GETTING STARTED
4.1 Typical Application
The above illustration shows a typical band setup with instrument and vocal inputs, four separate monitor mixes, stereo main L/R speakers,
and remote control from a laptop and iPad. Use the following procedure to safely and quickly set up the system.
1) Plug in all inputs, outputs, and speaker cables. Leave power amplifiers turned down at first.
2) One input at a time, set input trim controls so their loudest signal peaks are around 0dBu on the input meters (
sec. 2.1
)
3) Assign all desired inputs to the main L/R output using the Sends Mixer button (
sec. 2.9
), or the Assign button (
sec. 2.39
).
4) Select the main L/R output and turn its level all the way down (
sec. 2.3
)
5) Turn up power amplifiers, then slowly turn up the <Main> fader or volume control (
sec. 2.15
) until reaching a comfortable level.
6) Verify that all inputs can be heard in the main speakers or use the solo function (
sec. 2.19
). Select an input before adjusting.
