7
INSTALLATION (CONTINUED)
TABLE1
MODEL C D
AGDV8N - AGDV8L 19 ½” (495 mm) 6 ¾” (172 mm)
AGDV12N - AGDV12L 19 ½” (495 mm) 7 ¾” (197 mm)
AGDV20N - AGDV20L 19” (483 mm) 8 ¾” (222 mm)
Figure 5 Figure 6
2. Drill through the wall according to measurements and positions indicated.
3. Place hanging bracket over the hole. After leveling the hanging bracket, mark the four holes as shown in figure 6.
4. Remove the hanging bracket and drill the four holes.
5. Insert in each hole the anchors provided.
6. Place back the hanging bracket and fix it with four screws.
INSTALLING THE HANGING BRACKET ON A WOODEN WALL
1.
Taking into account the minimum clearances mentioned in figure 4, locate the closest wall stud (which will serve to
hold the appliance) and mark the hole center at a distance “A”, (if wall stud is at the right), or “B”, (if the stud is at
the left). See table 2 and figures 7 and 8.
2. Draw the position of the hole for the vent-air intake pipe. See diameter of the hole “D” and height to the center “C”
in table 2 for the different models. Height “C” is the minimum recommended.
TABLE 2
MODEL A B C D
AGDV8N - AGDV8L 5 9/16” (141 mm) 3 31/32” (101 mm) 19 ½” (495 mm) 6 ¾” (172 mm)
AGDV12N - AGDV12L 7 13/16” (198 mm) 5 7/16” (138 mm) 19 ½” (495 mm) 7 ¾” (197 mm)
AGDV20N - AGDV20L 13 11/64” (335 mm) 10 7/8” (276 mm) 19” (483 mm) 8 ¾” (222 mm)
Figure 7 Figure 8
