10
INSTALLATION (CONTINUED)
7. Before attaching the vent cap to the exterior wall, run a bead of non-hardening mastic (silicone caulk) around its
outside edge, so as to make a seal between it and the plate. (See figure 17).
8. Place cap and screw nut “E”, until cap leans against the plate. (See figures 16 and 17).
Figure 16 Figure 17
INSTALLING THE THERMOSTAT SENSOR
(MODELS AGDV12 AND AGDV20)
In order to protect the thermostat sensor from any damage during shipping, or while handling it before it is definitely
installed, the thermostat sensor has not been attached to its final location in the appliance.
So, once the heater is installed, the thermostat sensor must be placed and secured in position. To do so, follow these
steps:
1. Separate the front panel of the appliance by removing the two
nuts in the bottom and sliding it up as shown in figure 18.
2. Place the thermostat sensor under the right bottom of the
bracket and fix it with the same nut that fixes the appliance to
bracket as shown in figures 19 and 20
Figure 18
Figure 19 Figure 20
