35cm (13¾")
Insert the end of the flyer shaft into the rear flyer bearing and click the flyer orifice into the front flyer
bearing.
Tie the nylon brake band to spring . Thread the nylon brake band through the eye and tie spring
35cm (13 ¾”) from spring , then cut the surplus nylon off and tie it to the other end of spring .
Take the nylon brake band up and over the groove in the bobbin and place spring onto the hook.
Insert the tension knob into the maiden bar, thread the end of the nylon brake band through the hole in
the tension knob and tie a knot. Turn the tension knob to wind on excess nylon.
Take care not to over-stretch the springs.
Summary of Contents for KIWI 2 SPINNING WHEEL
Page 2: ...REAL SCALE HARDWARE...
