Lay the wheel on it’s back. (protect your table with a towel or piece of cardboard)
Remove the
front
conrod from the crank.
Insert the
front
conrod joint into the
right
treadle board. Hold the conrod joint with one hand on either
side of the treadle board. With both hands turn the conrod joint a ¼ turn towards you. Slide it up into
the small slot and turn it back a ¼ turn until it clicks into place.
Then repeat this sequence for the
rear
conrod and the
left
treadle board.
Finally click the front conrod back onto the crank.
NOTE: It easier to insert the rear conrod joint into the treadle board when the treadle board is at the
lowest point - turn the wheel until the rear conrod is in the lowest position.
Summary of Contents for KIWI 2 SPINNING WHEEL
Page 2: ...REAL SCALE HARDWARE...
