Ashford Jack Loom, Instructions Manual

Page: 10 / 16

10
14. Slide 5 treadles J onto the steel treadle rod with a round wooden
spacers k between. Add the centre block. Then add the next 5
treadles and round wooden spacers followed by the treadle blocks l
at either end. Note that the rod holes in the treadle blocks must be
towards the top. Then bolt all 3 blocks to
BX with M6 x 70 Cup Head
Bolt, M6 X 16 Washer, and M6 Nylock Nut. Tap the head into the
wood with a hammer.
15. Push a
M6 x 50 Cup Head Bolt
through
the inside of back upright CX and tap
the head of the bolt into the wood
with a hammer. Then attach spacer
P
through the hole with a
M6 x 22 Washer
and nylon knob.
16. Push a
M6 x 50 Cup Head Bolt
through
the inside of castle side EX and tap the
head of the bolt into the wood with a
hammer.
Locate the slot in spacer P
onto the
bolt
and secure with a
M6 x 22
Washer
and nylon knob. Repeat for the
other side.
Note:
The middle slot is used to hold
the back beam in the closed position.
Steel Rod
M6 x 70 Cup
Head Bolt
M6 x 70 Cup
Head Bolt
M6 x 70 Cup
Head Bolt
M6 Nylock
Nut
M6 x 16
Washer
M6 x 16
Washer
M6 Nylock
Nut
M6 x 70 Cup
Head Bolt
M6 x 50 Cup
Head Bolt
M6 x 50 Cup
Head Bolt
TAP IN WITH
A HAMMER
M6 x 22
Washer
M6 x 22
Washer
Nylon Knob
Nylon Knob
TAP IN WITH
A HAMMER
TAP IN WITH
A HAMMER