EN
12
Pool Water Connection
The pool water to be measured must be connected to ASIN AQUA Home.
Connect the measured water inlet downstream of the pump, upstream of the
filter and ZPM (coagulation mixer).
Place the water valve fitting to the T-joint, blinded by DN50 G1/4” threaded
plug #12134.
•
The connecting fitting is installed in G1/4” thread.
Aseko provides the unique Speedfit connecting fitting for measured water
connection to your ASIN AQUA Home. To connect the interconnecting
tube, push it into the Speedfit connector and then lock it by pulling back. To
disconnect the interconnecting tube, push and hold a circular collet and pull
the interconnecting tube out.
WARNING:
To treat PE tube ends, use a sharp knife (part of delivery). The
use of scissors or tongs deforms the tube end and leads to leaks.
WARNING:
Only hand tighten. Do not use tongs or any other tools.
1.
To ensure tightness of joints, cut the tube at 90 ° angle.
•
Use the sharp knife to cut plastic. The cut must be clean and smooth.
2.
Connect the water inlet to the measured water filter connection and the
water outlet to the probe housing connection. Make sure that measured
water pressure does not exceed 1.5 bar.
3.
The water outlet can be realized:
1. downstream of filtration
2. to non-pressure (overflow tank)
3. upstream of filter pump
After the water inlet has been connected and opened, your
ASIN AQUA Home is ready to measure and adjust the pH and Cl value in your
pool so as to achieve the required values.
Water valve
fitting
G1/4” thread
6.2x4 hose
CONNECTION
LOCKING
DISCONNECTION
Water valve fitting
Inserting DN50
plug
G1/4” threaded
T-joint
6.2x4 hose
90°
Pull out