TD 92326GB
2009-03-10 / Ver. E
Installation and Operation Manual
VoIP Gateway
82
1
Select PBX > Calls.
Figure 63. Shows active calls
A complete call with two subscribers is displayed on each line. The data of the first
subscriber is displayed in the first three columns (E164, H323 and Media), the call direction
is specified in the fourth column (Dir) and the data of the second subscriber is displayed in
the following three columns (E164, H323 and Media).
The call status is indicated in the last column (State). The calling party is generally referred
to as the first subscriber, the called party as the second subscriber. The Calls list is updated
approximately every fifth second.
See also
11.7 SOAP – Display Active Sessions
Note:
Not supported by Ascom.
Figure 71.
Field name
Description
• Number
The calling number
• Name The
calling
name
• Protocol
Used protocol on the calling side
• Media
Announcement of the Coder used on the calling side. For example
G711AB (2,0,0). The values in parentheses mean in order:
• round trip (blank) = running time of a packet from A to B and
back again.
• jitter = latency (time interval from the end of an event up to the
beginning of the reaction).
• loss (PL) = number of missing packets (Packet Loss).
• Dir
In the condition alerting “>”. and in the condition connected “>>”.
• Number
The called number
• Name The
called
name.
• Protocol
Used protocol on the called side
• Media
Used Coder on the called side
• Uptime
The call uptime
• State
Possible conditions: Alerting, Calling, Connected, Disconnecting.
