62
20324744en_ba_a0
Operation on a PBX
You can also connect your Ascom Eurit 4000 to an ISDN PBX (private branch exchange)
via the S
0
bus. In this case, however, you must consider the special characteristics of the
telecommunications system you are using. Therefore, before connecting your Ascom Eurit
4000 to the network of the telecommunications system, read the instructions for use of
the system and be aware of its capabilities.
In order to ensure the satisfactory operation of your Ascom Eurit 4000 on a
telecommunications system, you may have to make some settings. Although your
telephone is already preconfigured by default for the majority of all telecommunications
systems, there can be no guarantee that these default settings are right for your
telecommunications system.
Therefore, follow these steps in order to avoid mistakes when setting up your telephone.
➭
The settings described below are contained in the "Installation/PBX" menu.
Switching on/off operation on a PBX
Operation on a PBX is the same for all users.
Select the "PBX" line and press the OK key.
From the pop-up window, select "Yes" and press the OK key.
save
Press the Fox key below
save
.
Trunk access code (TAC) for outgoing calls
In order to phone an outside number (one not connected to your telecommunications
system), it is necessary in the majority of systems to precede the phone number with the
TAC (Trunk Access Code). The TAC tells the telecommunications system that this is an
outside call.
The majority of telecommunications systems use "0" as the TAC. Your Ascom Eurit 4000
is therefore preset to use "0". However, if your telecommunications system requires a
different or no TAC, then replace the presetting of "0" with the TAC required by your
telecommunications system.
Select the "TAC outgoing" line and enter the TAC required by your
telecommunications system.
save
Press the Fox key below
save
.
