AP201CWT GPON 1 GE + WiFi ONT
Solutions Provider for FTTx, RFoG and HFC www. ascentcomtec.com
Page 13 of 32
not manually set the static IP address. It is used as a relay device and does not process the
data. There are three ways to obtain the IP address of the user side device, namely
DHCP
,
PPPoE
,
and
Static IP Address
.
Login ONU WEB, select
Internet -> Internet Config -> Internet Config
, and then there are
some parameters for us to configure as follows:
【
WAN Connection name
】
Select ‘Add WAN Connection’
【
Mode
】
Select
‘
Route
’
【
Connection Mode
】
Select ‘Ipv4’; If there is Ipv6 in the network, we can select ‘Ipv4/Ipv6’.
【
Internet way
】
Select ‘PPPoE’
【
NAT
】
Check ‘NAT’ feature; NAT is mainly used for address translation function of local
network and external network. The default is checked enable status. If you do not check this
option, maybe you can’t surf the internet.
【
Enable Vlan
】
We can set this option according to your network plan. If there is VLAN in the
network for internet, we have to check ‘Enable VLAN’ option. If not, we needn’t check this
option, which will be VLAN transparent mode.
【
Vlan ID
】
Configure this option according to our network plan.
【
MTU
】
The default is 1492; we have to change to lower MTU,
such as 1400
, if we can ping
the DNS but not access the website via WEB browser.
【
User Name
】
Type PPPoE account, normally offered by ISP, for Internet
【
Password
】
Type PPPoE password, normally offered by ISP, for Internet
【
Service Mode
】
Select Internet; Normally, select ‘ Internet ’ in the route mode.
【
LAN DHCP Disable
】
Don’t check this option; Normally, Terminal, connected to the HGU
ONU, will get an IP address from the ONU’s IP pool. Therefore, we needn’t check this option
to get the IP address.
【
Bind port
】
Bundle the physical ports (Lan port 1-4 and wireless) with PPPoE WAN
connection.
Note
By default, all LAN ports and WIFI data are not bound by this WAN connection (a LAN and WIFI
SSID can only be bound to a WAN connection at the same time).
