MAINTENANCE
LAMP CONTROLS:
This ventilator may require two 50W GU10 halogen or two 3W GU10 LED lamps.
WARNING:
Always switch off the electrical supply before carrying out any service on the appliance.
HALOGEN LAMPS OR LED GU10 BULBS:
To change bulbs:
1. Turn off unit and wait for lamps to cool down before removing.
2. Rotate the lamp by turning counter clockwise, pull out bulb.
3. Replace with GU10 Halogen (50W) or GU10 LED (3W) bulbs.
CAUTION:
1. Halogen bulbs can be especially hot. Care must be taken when removing to prevent injury.
2. Use only lamps as specified above.
VENTILATOR CLEANING
Stainless steel is one of the easiest materials to keep clean. Occasional care will help preserve its fine
appearance.
• Hot water with soap or detergent is all that is usually needed.
• Follow all cleaning by rinsing with clear water. Wipe dry with a clean, soft cloth to avoid water marks.
• For discolorations or deposits that persist, use a non-scratching household cleanser or stainless steel
polishing powder with a little water and a soft cloth.
• For stubborn cases use a plastic scouring pad or soft bristle brush together with a cleanser and water.
Rub lightly in direction of the grain of the stainless finish. Avoid using too much pressure that may mar
the surface.
• Do not allow deposits to remain for long periods of time.
• Do not use ordinary steel wool or steel brushes. Small bits of steel may adhere to the surface causing
rust to form.
• Do not allow salt solutions, disinfectants, bleaches, or cleaning compounds to remain in contact with
stainless steel for extended periods. Many of these compounds contain chemicals that may be harmful.
Rinse with water after exposure and wipe dry with a clean cloth.
• Painted surfaces should be cleaned with warm water and mild detergent only.
6
