IPCOM-4G
Introduction
The IPCOM-4G Mobile Communicator is recommended for security installations, where the reporting to Alarm Monitoring
Service providers (AMS) has to be made over Ethernet and/or mobile networks. The main reporting channel is the
Ethernet network, and the mobile internet network, as a backup.
The device is equipped with two I/O ports (the type of the ports can be NO/NC). The outputs of the module can be
controlled via SMS and phone call as monostable. In addition, the control with phone call is possible only with phone
caller identification, therefore, 8 phone numbers can be set to manage the outputs.
The ports can be used also as contact driven inputs. In case of arriving signal to any of the 2 inputs, the module can send
an SMS to one phone number, moreover, the module is capable of sending a message to the monitoring station as well.
Also, we can link zones to the inputs. The IPCOM-4G is able to translate the contact ID codes, which were sent by the
alarm panel, to SMSs. Also we can give unique names up to 16 zones.
The module can be programmed by PC via USB directly, or via IP network.
For all ways, a primary and a secondary channel can be given. The secondary channel can be used as a backup, or for
parallel reporting (double reporting).
To be able to use and understand all the features of the IPCOM-4G series communicators, please, read this
Installer
Manual
carefully.
SAFETY NOTICE!
Please, take care of installing and using this product according to the instructions and procedures
detailed in this manual to ensure proper product safety.
System overview
The IPCOM-4G communicator receives the messages from the telco interface of the security control panel, in Contact ID
format, and forwards these through the wired or mobile internet network or cellular network to the Alarm Monitoring
Service central.
Page 3
GSM
Router
Ethernet
internet
AMS receiver
IPCOM-4G
GPRS/3G/4G