Asante FriendlyNET VR2004 Series, User Manual

Page: 44 / 76

FriendlyNET VPN Security Router 44
•
Remote IP Network : 192.168.123.0
•
Remote IP Netmask : 255.255.255.0
•
Remote Gateway IP : 172.16.0.123
•
Network Interface : WAN ETHERNET
4.2 Client-to-Network
To connect a remote client PC to your network, use one of the fol-
lowing configurations based on the type of IP address of the client:
Mode 1— Dynamic IP Address
The remote PC obtains a dynamic IP address, and the user has to
setup the IPSec Client software (i.e. SSH). In this case, you must
configure the router with the following:
•
Remote IP Network : 0.0.0.0
•
Remote IP Netmask : 0.0.0.0
•
Remote Gateway IP : 0.0.0.0
•
Network Interface : The interface on the router used to
communicate with the remote network. Most users should
leave this set to WAN ETHERNET
•
Local IPSEC Identifier : Allows you to identify multiple tun-
nels and does not have to match the name used at the
other end of the tunnel. This field may remain blank. The
default value is
Local .
•
Remote IPSEC Identifier : Allows you to identify multiple
tunnels and does not have to match the name used at the
other end of the tunnel. This field may remain blank. The
default value is
Remote .
Note : If you need to use Manual Mode (as described in
section 4.4), you must enter valid addresses in all the
fields, as they cannot be 0.0.0.0.
Mode 2—Static (fixed) IP Address
The remote PC obtains a fixed IP address, and the user must setup
the IPSec Client software (i.e. VPNCOM) that will act as a virtual
NIC card (the PC will appear to the router as a virtual NIC card). In
this case, you must configure the router with the following: