9
8
Seal Mode
Should your product not perform properly, restart it.
Check nozzle and operating mode.
See “Before Placing Items in Bags”, page 7 to prepare the bag.
Insert the bag farther than the position of the PTFT strip, until the tip of the bag
contacts the end of the unit.
When setting an embossed bag, be sure to place it with the embossed side down.
Press the start button to begin the sealing process.
Press the start button at the bottom right of the unit, and the seal bar moves
down to begin the sealing process. When the process is complete, the seal bar
moves up automatically.
Make sure red and green lights at both sides of the cover top are illuminated and
nozzles are housed. In other modes, press the select button to change the mode.
Plug in the power cord and turn on the power.
The power switch is on the right surface of the unit.
Make sure to indicate the number on the cover.
Red light (Left)
: Automatic Vacuum Mode
Green light (Right)
: Manual Vacuum Mode
Red & green lights
: Seal Mode
Set the sealing time.
Set the seal timer taking bag thickness and
material into account.
（Seal timer number：1=1sec、2=2sec ...)
Sealing time (sec.)
＋Button
−Button
Checking the seal condition, set the appropriate
seal time.
Place item(s) in the bag.
Place the bag.
Place the bag.
The bag is positioned so that it
straddles the vacuum nozzle.
Be sure to insert the bag as far
as possible.
Press the start button.
Make sure the sealing process is complete and
remove the bag.
The seal bar moves down and holds the bag.
When the sealing process is complete, the seal bar will move up automatically and
the unit will stop.
House the nozzle.
House the nozzle before shutting off the
appliance.
Press the select button and the nozzle
will move down.
Turn off the power.
Be careful that the bar does not pinch your fingers.
Automatic Vacuum Mode
Manual Vacuum Mode
When the unit vacuums for 60 secs or
the vacuuming is complete, the
sealing process will begin
automatically.
Press the start button again and turn
on seal mode.
To avoid wrinkling, stretch the bag sideways while inserting.
7
8
9
10
11
When setting an embossed bag,
be sure to place it with the
embossed side down.
In the embossed bag mode, switching to the sealing operation is possible by
pressing the start button.
In the automatic vacuum mode of embossed bag, if the machine does not move
to the seal mode even though the suction is sufficient, press the start button.
Please adjust the seal timer and use the thinner embossed bags when the sealing
process will not begin in the automatic embossed bag vacuum mode.
The seal bar moves down and begins vacuuming items.
During vacuuming, bringing the contents close to the nozzle expedites the loss
of air from the bag in standard vacuum bags mode .
In the embossed bag mode, pre-sealing begins first when the bar moves down,
then vacuuming is performed.
